Clean Jetted Whirlpool Tubs

Whether you have an old or new jetted whirlpool tub, it is important to clean it after each use. This will help to keep it in great condition and make it last longer. It also helps to remove any buildup that may be lodged in the jets. If you are wondering how to clean a jetted whirlpool tub, you can use a variety of cleaning products. You can also use a special jetted tub cleaner. Using a brush will help to remove any grime that has been clinging to the jets.

You can use an old toothbrush to clean the jets. The brush can get into nooks and crannies where you may not be able to see it with your naked eye. You can also clean the jets with a microfiber cloth. You should not use any type of whirlpool tubs as it could scratch the tub.

If you do not want to use abrasive cleaners, you can use vinegar. Vinegar has an acid that will help to break up the buildup in the jets. You can leave the vinegar in the tub for about ten to fifteen minutes to help with the cleaning process.

How to Clean Jetted Whirlpool Tubs

You can also use baking soda to clean the jets. You can either use a spray bottle or a scouter to apply the baking soda to the waterline and water faucet. You can also scuff the baking soda with a damp cloth to remove any residue that may have collected. You can also use a microfiber cloth to wipe away the grime that is collected in the jets. You can also use dental floss to clean the nozzles.

Another option for cleaning your jets is to use a mixture of vinegar and hot water. You can leave the mixture in the tub for about ten to fifteen minute, but you may need to run it for a little longer if there is a lot of buildup. You can also use non-chlorine bleach and powdered dish detergent to clean the jets. This will help to disinfect the jets and remove any black grime that may have collected. It is recommended that you wear gloves and goggles while using bleach.

If you have a jetted whirlpool bathtub, it is best to clean it every month. You should make sure that you clean the jets and the exterior components of the tub as well. You may also need to use dental floss to wipe away any grime that has collected on the handles or the faucet.

After you have cleaned the jets, you can re-run the jets with clean water to rinse away any leftover buildup. The water should run over the jets several times until no more black grime has ejected from the jets. You should then drain the tub and refill it with warm water. You may want to use a non-abrasive liquid cleanser to keep the acrylic from getting scratched.

You should also ensure that the water is filled to the proper height before running the jets. This will prevent damage to the pumps and ensure that you are washing the jets properly. The water level should be about two to three inches above the top of the jets.